What’s in the box
The box should contain: the speaker, an audio cable (3.5mm AUX), a charging cable (USB-C), and a manual. If anything is missing, send us a message at info@valco.fi.
Charge first
Before you start, charge the speaker fully. Connect the USB-C cable to the charging port on the speaker (port 7, under the protective flap) and the other end to a suitable charger (5V / 3A). The red light stays on while charging and turns off when the battery is full. Charging takes about 2–3 hours.
Bluetooth pairing
1. Press and hold the power button (button 1) until the speaker turns on.
2. The blue light starts flashing – the speaker is in pairing mode.
3. Open your phone’s Bluetooth settings and search for "Nordell MK3".
4. Tap it and pair the devices.
5. Once connected, the blue light stops flashing and stays solid.
Next time, the speaker will automatically connect to the last used device.
Switching audio source
Nordell MK3 supports three audio sources: Bluetooth, Micro SD card, and AUX cable. Switch the source by pressing the M button (button 2) briefly.
Technical specifications
Bluetooth: 5.0, range about 10 m in open terrain
Power: 20W × 2 – enough to wake a sleeping partner
Frequency response: 80-20,000 Hz
Battery: 5200 mAh, up to 15 hours at 50% volume, at least 8 hours at full blast. Supports fast charging.
Charging time: 2–3 hours (5V / 3A)
IPX7 – handles rain, splashes and bathroom use, but not deep-sea free diving.
Supports microSD cards (max 64GB). MP3 plays for sure; we make no promises about other formats.
Built-in microphone for calls, with Siri and S-Voice support.
